产品详细说明:
根据雷电分区的概念,该电涌保护器可安装于LPOA-2及更高界面或者直接安装于靠近被保护设备的前端。适用于工业控制各种信号,0-20mA,4-20mA控制线等输入输出接口的电涌保护。
For installation at LPOA-2 or higher,or directly at the upstream near the protected devices. Provide protection for measuring and cintrolling system, such as the field bus,input/output interface of the 0-20mA,4-20mA control line.
◆ 由两部分组成,底座和电涌保护模块
Composed by two parts: the base and the protection module
◆ 切换保护模块时信号传输不会被中断
The signal will not be disconnected when replacing the module
◆ 放电能力强,电压保护级别低
High discharge capacity, low voltage protection level
Type | 型号 | IEC-ITS-CD | |
Order N0. | 货号 | N0. | 801 048 |
Nominal a.c. voltage | 标称电压 | UN | 48V |
Max. continuous operating a.c. voltage | 额定电压 最大持续电压 | Uc | 54V |
Nominal current | 标称电流 | IN | 0.5A |
Lightning impulse current (10/350 μs) | 雷电冲击电流 (10/350 μs) | Iimp | 2.5KA |
Nominal discharge current (8/20 μs) | 标称冲击电流 (8/20 μs) | In | 5KA |
Total discharge current (8/20 μs) | 总冲击电流(8/20 μs) | In | 10KA |
Open circuit voltage (1.2/50 μs) | 开路电压 (1.2/50 μs) | Uoc | 10KV |
Voltage protection level at 1kv/μs | 1kv/μs电压保护水平 | Up | ≤55V |
Voltage protection level | 电压保护水平 | Up | ≤140V |
Series impedance | 串联电阻 | R | 1.0Ω |
Response time | 响应时间 | tA | ≤1ns |
Operating temperature range | 工作温度范围 | Tu | -400C – 800C |
Dimension | 安装宽度 | 12mm | |
Test standards | 测试依据 | IEC61643-21;GB18802.21 | |
Certification | 认证 | CE、 ROHS… |
双绞线避雷器,双绞线防雷器,双绞线浪涌保护器,双绞线电涌保护器,0-20mA避雷器,0-20mA防雷器,0-20mA浪涌保护器,0-20mA电涌保护器,4-20mA避雷器,4-20mA防雷器,4-20mA浪涌保护器,4-20mA电涌保护器,模拟量避雷器,模拟量防雷器,模拟量浪涌保护器,模拟量电涌保护器,开关量避雷器,开关量防雷器,开关量浪涌保护器,开关量电涌保护器,脉冲量避雷器,脉冲量防雷器,脉冲量浪涌保护器,脉冲量电涌保护器,I/O避雷器,I/O防雷器,I/O浪涌保护器,I/O电涌保护器,信号避雷器,信号防雷器,信号浪涌保护器,信号电涌保护器,控制避雷器,控制防雷器,控制浪涌保护器,控制电涌保护器,消防避雷器,消防防雷器,消防浪涌保护器,消防电涌保护器,工控避雷器,工控防雷器,工控浪涌保护器,工控电涌&